Customer Reviews for VEVOR Stainless Steel Kettle, 18.9 L Brewing Pot, Tri Ply Bottom for Beer, Brew Kettle Pot, Home Brewing Supplies Includes Lid, Handle, Thermometer, Ball Valve Spigot, Filter, Filter Tray

Great product and great service

El tanque muy bien, lo hemos utilizado para pasteurizar zurmo de manzana y embotellarlo, por su grifo. El uso ha sido estupendo y la atencion al cliente tambien. El servicio de reparto DHL es lo que fallo y demoró mucho la entrega, dimos hasta por perdido el paquete., ya que tardo en llegar 20 dias. Pero el servicio de atencion al cliente de VEVOR funciono muy bien.

Good product for the price. The o-ring seals for thermometer and valve need some quite much teflon tape to be tight. The bottom plate is also quite thin, this is ok thow as i use it with gas burner. In overall this is good product concidering the price. Would buy again!

Très bien mis à part quelques points de rouille qui apparaissent, sur de l'inox c'est moyen

Good product. Promptly delivered good value for money

J'ai fait 4 brassins dessus, la cuve semble de bonne qualité le seul point négatif c'est le fond filtrant qui est trop gros dommage.

Nice heavy duty kettle. Wish it had embossed water levels, but I put a sharpie mark on the level I need, and it works. No leaks, great price for this size kettle.

Works great for our brew room!

Great pot for the price, Very sturdy, and yet light. This is a great size for a large pot. Anything bigger becomes very difficult to handle/stur/clean. No major complaints or concerns. The pot assembly was of average difficulty. I took the valve apart because reviewers claimed there was a large amount of automotive lubricant inside the valve body. I only found a moderate layer over very sticky automotive grease in the valve, which would give an off flavor for the first few uses until it wore off. The valve took some force to disassemble, but no parts were damaged. I removed the grease from all internal surfaces with lots of scrubbing with dish soap followed by scrubbing with 90% isopropyl alcohol. It was tough to remove. I think probably all pots under $400 probably have valves with automotive grease in them. You get what you pay for and I was extremely satisfied with the cost and functionalitie of this pot. The screen works fine and is decent quality. I add a washcloth on top because I am cooking corn meal and don't want the fine powder to fall through the screen and scorch. I have used the pot several times now and the only time it leaked at all when completely full is when I hit the temperature probe several times with a large mixer attached to a drill while at cooking temperature. The pot leaked a tablespoon of liquid then stopped, no maintenance needed. The temperature probe is strong. My only complaint here is that I feal the gage is not quite accurate through the entire temperature range from 40 F to boiling. If you set the guage to be accurate at one end it seems off by around four or five degrees at the other end of the range. I am not certain because I do not have a calibrated guage to check against it and my laser thermometer is not super accurate with liquids and stainless steel. The guage is handy to have installed because the temperature at the top of the pot can be 40 degrees different than the top with high starch liqids, because the liquid does not

Recieved the pot box was seriously damage but luckily no damage to pot. Assemble according to directions which are lacking all details needed. Ended up with a slow leak on both ports. I took it apart to find large burns on the inside at each punch hole. Needed to sand those down. It also doesn't mention that the stainless internal nuts have groove cut in on one side of the nut that secures the rubber washer. Overall worth the money.