Customer Reviews for VEVOR Annular Cutter Set, 6 pcs Weldon Shank Mag Drill Bits, 2.5 cm Cutting Depth, 1.27 to 1-2.7 cm Cutting Diameter, M2AL High-Speed Steel, with Pilot Pin and Portable Case, for Using with Magnetic Drills

HAN SIDO EL COMPLEMENTO AL TALADRO MAGNETICO QUE COMPRE, CASI TAN CARAS COMO EL PROPIO TALADRO, PERO PARECE QUE VAN BIEN, CON UNA DE ELLAS HE REALIZADO UNOS TRESCIENTOS TALADROS EN ESPESOR 4 MM Y 20 EN 10 MM Y NO APRECIO NINGUNA PÉRDIDA DE RENDIMIENTO. ESTOY MUY CONTENTO CON EL CONJUNTO.

Am testat și sunt dintr-un material făcute care nu se uzează f repede sunt momentan mulțumit de ele mulțumesc.....

They are pretty good for a cheap set. I have only use them a few times and they worked. I do not expect them to last a long time.

Ce produit coupe très bien. Le seul défaut c'est que la mèche pour centrer n'est pas au centre. Et je me demande s'il existe des compagnies pour en font l'affûtage.

Bits last and good while. Price, in comparison is good, consideri g yhey last as long or longer than name brand bits.

Bought both 2 inch kits with a mag drill. The initial cost adds up but I think it's worth it in the long run. I've drilled several holes in 3/4 inch steel plate with these.

This is a great set of annular cutters. Absolutely no complaints at all. I started using the day after they arrived, and I have used nearly all the sizes. They are very precise and very sharp. They seem to be holding up very well. I give this a 4/5 only because the nice case it comes in was smashed into about 14 pieces, which is too bad, because it looked to be a decent case with a foam holder. I went to Harbor Freight and bought a nice divided case to put them in. So, if you expect the case to be busted, it is a very very nice set of cutters that will last a long time. Great price and great quality. I would have no problem recommending this to anyone.

have used a few bits now all fine except the 1.75" exploded first use...reached out but slow replys and need resolution!!

I ordered these thinking that they would fit my Vevor Mag Drill and found out that they were not the same as what came with the mag drill a bit useless to me. the annular Cutters do look good but can't use them

Qualité très moyenne, ne convient pas à un usage professionnel. Ok pour fer de faible épaisseur.