Customer Reviews for VEVOR 1-Inch Air Impact Wrench, Twin Hammer Air Impact Gun, Up to 1626N.m Reverse Torque, 4600RPM 6-Speed Pneumatic Wrench for Heavy Duty Auto Repairs and Maintenance

For $40 not too much to complain about. However, I would like if it had a locking chuck on it. Getting a socket on it is more difficult than other wrenches because on this one the cuck spins really easily and freely. So, every time you go to snap a socket on it - it moves a fraction and you can't get the thing on unless you physically hold the cuck from spinning. Not ideal.

Happy with this so far. I own a small Auto mechanic shop and use it daily. Ton's of torque and holding up nicely so far.

Defective Out of the Box – 1/2" Impact Wrench Seized (Order #26111200961200430961) I received this combo kit on Order #26111200961200430961 and followed all manual instructions, including adding air tool oil before connecting air. The 3/8" ratchet wrench works normally on my 125 PSI air compressor, proving my air line and pressure are fine. However, the 1/2" impact wrench (Model WFI-1070) arrived completely seized out of the box—it makes a dull thud with zero air flow and zero spinning when the trigger is pulled. As shown in my attached video, this unit is defective on arrival. Please provide a prepaid return label for a full refund or a working replacement under VEVOR's Free Returns policy.

Stopped working on the second tire change. I didn't even own it for a year.

Would not buy again. Came apart during the 5th use. I oiled each use. I’ll keep the sockets it came with but had to replace the gun. Spend a bit more on a quality impact. Take a pass on this one.

air hammer exploded on first use, oiled it well and had psi set to 35, hoping the will be able to replace.... everything else seems to work well, the case doesn't hold most of the sockets and accessories, they all fall out to the center when you open/close

Complete waste of money! Bought kit for the 1/2 inch impact gun and its total junk! Oiled it up, hooked it up to air, hit the trigger...and the seals inside are shot! I can stop the socket with my bare hand. The case it came with is a joke, dont hold anything in place to shut and stow away. If i didn't cut the case into 3 sections to fit in my tool chest drawer, I would request a refund! May just throw it all away or list for free on marketplace. You get what you pay for. Beware of this item...definitely old new stock.

Item worked as intended. Had to rewire switch after initial use because cord as too tight and pulled contacts off switch. Repaired and working fine.

Very low quality .work only 1 month and then doesn't work properly.

2nd use leaks air out of trigger not strong enough to loosen nuts had to go back to pry bar now stuck with a brand new tool that doesn't work and my garage is full of vevor products that work perfectly .