Customer Reviews for VEVOR Transmission Fluid Pump 2 Way ATF Refill System Dispenser, Oil and Liquid Extractor 10 Liter Large Capacity, Automatic Transmission Fluid Pump Tool Set with 14 Pieces ATF Filler Adapters

I bought this to fill out the automatic transmission of my SUV which takes about 7 liters. It takes a lot of hand pumping and it leaks oil so make sure you put it on some absorbent mat or towel. I only use one of the hose attachments so I can speak about the others. But it is better than the smaller cheaper pumps so it get the job done.

todo bien

I have not used it yet. But it looks like it's going to work for everything I could use it for like pumping bad gas out of cars.

Works as intended. Will not work with a twist style dipstick. Other than that it works great. Use it on lawnmower oil changed.

Bought this for my Malibu. It is so low to the ground that it is difficult to change the oil. The smallest hose only went 8 inches down the dipstick. It will work for my pickup and my van but no luck with the Malibu.

Pues compre esta bomba o estractor porque el tornillo del carter me fue imposible sacarlo, el antiguo dueño o el ultimo mecanico que lo vio no se cuanta fuerza uso para apretarlo. Entonces compre esta bomba/estractor antes que las "automaticas" y la verdad que muy bien !! La he usado una sola vez, pero sin problemas y extrajo si no todo el aceite casi todo y sin mayor trabajo.

So, for the money, it dose what it's supposed to do. I had no real problems as far as use goes or any complications. I wish there were more details in the directions and a good way to clear the suction hose in between one job to another. I would buy again, that's the real point right!!!

Good product

Easy to use. Works like it should. A must for lawn mower and import cars!! I used to to drain chlorine, old gas,

This fluid extractor worked great when attached to my air compressor. The included extension was need but worked for the transmission fluid of my 2007 Durango and my 2011 Ram P/U. My only gripe, which is very irritating, is the storage cylinder had this angled line that states to Not pour out your fluids too fast and allow your fluid level to go above this line. This is great because you don’t want nasty sticky fluids to get clogged in your vacuum pump. Problem is this design! I was Nowhere Near the line as I only had 6.5L of fluid to pour out; however ATF started spewing out of both sides of the manual pump handle! There was zero reason for this. Now when I pump the manual lever, residual ATF leaks out of both sides of the pump handle.