Customer Reviews for VEVOR Running Boards, 6" Step Bars Compatible with 2007-2018 Chevy Silverado/GMC Sierra 1500 Crew Cab/2019 2500HD 3500HD 1500 LD, 201 Stainless Steel Side Steps Nerf Bars, 500LBS Capacity, 2 Piece

The boards look good . Due to health reasons have not instal them yet.

Alight delection when stood on but still decent for the price.

I really like these running boards. I did not install so Im not sure about how well that went. I gave 4 stars because on the black step piece at the end, it is just slightly hoved which will allow water to lay under it with dirt and could cause a rust issue rather quickly. But I will assume it was just mine that had a slight flaw. I ve only run them for a few weeks so we'll see how long they stay shiny and pretty.

Really nice finish, decent quality, affordable. 2017 chevy 1500 , 4 full size doors.

These look just like the very expensive GM running boards. Fit well. I did notice some rust staining coming from underneath the plastic pads but it washes off easily. I assume the rust is from plain steel washers that are used under the pads. The paint on the brackets will not last since there are no plastic protective covers like the GM product has but at this price point I'm ok with that. I will paint the brackets as needed.

They are really good for the price. They are not a tube, they are a channel. I was replacing some chrome steps that the Crome was coming off. These are stainless steel so that will not ever happen again. However I would have paid an extra $100 if they were a tube. That why I could not give one more star.

Well packaged, with all required hardware. Once all the old running boards and mounts were removed (if this is your situation) install was a breeze and took about 45 minutes. Use of an impact drill or air ratchet is recommended. Quality appears to be a 3/5 - metal is a bit thinner than I hoped. Apperance - 5/5, looks sharp and is exactly as shown. Durability - 4/5, stands up well so far.

tres facile a installer donne un look tres beau a mon jeep

The nuts in the running board turned when tightening them and not using alot of force or over tightening

Bottom line: these are good, but you gotta take your time. The directions are not very detailed! Took me a whole day to get the first side on because I had to figure out what I was doing! You can do it by yourself, but you will need a car jack to hold it up while you tighten it in place! get everything set where you want it and then go back and LOCTITE EVERYTHING. If you do it the right way, you'll have a rugged set of running boards that don't wiggle, don't rattle, and don't sag. If you just bolt it up without a care in the world, the running boards will sit VERY low to the ground. The brackets themselves and the running boards are good quality! Idk if it'll hold 500lbs like it says, but I can get in and out, and reach the roof of the truck with any movement. I would post a photo, but the file size is too large.