Customer Reviews for VEVOR Gutter Guard, 5 inch Width, Aluminum Leaf Filter DIY Gutter Cover, 13 PCS 52 ft Total Length, 0.157'' Hole Diameter & 0.02'' Thick Raptor Gutter Guards Fits Any Roof or Gutter Type

These are good quality and not too flimsy. The only negative is that they come with a bunch of mounting screws, but those are oversized the for the job--they will work but you will see the heads of them from the ground. I used small soffit screws instead. Also, an improvement would be oblong screw holes to allow for a bit of thermal expansion and contraction. We'll see how they perform over time. Instructions are minimal. They should include how to cut pieces to overlap in a corner.

Overall decent product,two issues , package came pretty beat up and a number of panels were bent, second the hex bit's magnetic properties leave much to desire. Ended up switching out and using my own

They are easy to install and are beautiful to look at , the only issue is the holes in it don’t stop pine needles from sticking and piling up .

The gutter guards snap into the eavestrough very easily, are simple to install, and even give the gutters some structural rigidity. The supplied screws are not great though. They are self tapping, which is fine, but the tapping end is too large for the thread of the screws, meaning they have no holding power. I stopped using them after installing a few sections and instead used some soffit screws that I had on hand, which secure the guards to the gutters very well. I would recommend that regular soffit screws be supplied with this product instead of the large self tappers.

Guards were good quality and about 1/2 thre cost of big box stores. I had 200 feet of gutters and at 4' long that's up and down, move the ladder 50 times. Oh well, worked out OK. Would recommend .

This 52 piece set of gutter guards was just the ticket I was looking for. I ended up with 3 feet left over on my 1580 sqft house. Although the package was damaged during shipment and lost a bunch of hardware, which Vevor credited me for the loss, the installation was simple. The guards could have been a bit wider, by 1/8 inch, for a tighter fit, as my drip edge covered the back side of the guard and I couldn't use fasteners to anchor them in place. The fasteners did not hold tight, the threads seem to be same size as the self-tap drill. Bottom line, I believe they will work as advertised, decently priced, easy to modify and cut. Time will tell how durable and efficient they are.

Great product

The wrong screws are sent with this product. These are self tapping screws and penetrate the gutter without being able to tighten them. Please put the correct screws in.

Was a bit difficult cutting and trimming around corners but other than that, it worked very nice

good product add to buy and additional packages to complete my house. Easy to install.