Customer Reviews for VEVOR Blacksmith Tongs, 45.7 cm 3 PCS, V-Bit Bolt Tongs, Wolf Jaw Tongs and Z V-Bit Tongs, Carbon Steel Forge Tongs with A3 Steel Rivets, for Beginner and Seasoned Blacksmiths, Bladesmiths and Craftsmen

I purchased this set of tongs because frankly, I can't make them for this cost. So far I have been pleasantly surprised. Recently making a set of hatchets I found the hammer eye tong to be particularly useful. The tongue rings and have a ball at the end to allow using tong clamps to hold them shut. On square stock the v bit songs have a good grip. The reins are beefy.

The tong handles are made nice, the wolf jaw are best - the v bit is a little to large for what I’m using it for, but it works! Haven’t tried the Zv’s yet, but confident it’ll do just fine

On hyvät eli saa pitävän otteen ja hinta kohdallaan

Correcte

The tongs are pretty good. They are a bit on the heavy side but they get the job done. Now that I have some I can make my own custom ones.

solid and cheap tongs. I needed to do some small adjustments to the tongs to fit my use, but these are great for beginner blacksmiths.

Not to bad. They are a bit heavier than my old hand made tongs. They do take some adjustments to hold tight. As sold they have as limited range where they're "happy". But over all a good product and I'd recommend. Chuck. Mýri Afla* *Swamp Forge

the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work, the reins will need a little modifying and though I have seen far worse they could be made to work,

Great starter tools. Not to hard to reshape to fit your purposes. Would recommend as a starting set of tongs.

NOT wolfjaw tongs. Missing groove down the center. It is uncomfortable to hold anything in line with them, but if you need to hold anything adjacent, that is perpendicular/90 degrees, then these are the tongs for you. I will be buying from another place as I need legitimate wolfjaw tongs for most of my work. The finish on these though are quite nice, however.