This is my first server rack i have ever purchased or used. Putting it together is not as bad as i have seen many others say for the reviews of this. I did have a small problem aligning some holes during assembly but it was from over tightening screws. There is a section near the bottom that secures two 90 degree angles together but is blocked by the nut for the caster wheels. I however did not have any damage from the factory. Paint finish felt just fine but will scratch off if you aren't careful. I think the parts were shipped in a very clean manner and were all labeled what part was what, minus the screws. After i finished assembling the unit i thought it was more than sturdy for what purpose it serves. Is it going to survive being thrown off the roof? Probably not, but for its intended use it seems more than solid and only takes about an hour to setup. It did say you need two people, but i did it by myself, with some patience. The only flaw to the entire cabinet is that NONE of the adjustable parts secure together with nuts. The entire cabinet is assembled using M5 screws and you must force thread the holes with the screws. They are not self tapping either from the looks of it. It seems solid enough with the way it went together so I'm going to try and not beat this around too much so it doesn't become flimsy. I would very much so recommend that you use a drill with a Philips bit and set the clutch to a medium strength. You also have to be careful you match both sides of the adjustable racks so a part isn't installed backwards or upside down because it can very easily look like it was assembled right. To be very honest i would give this a 4.5 out of 5 only because i feel that the assembly instructions could use some improving.
Theodore Quinn 
