Customer Reviews for VEVOR Metal Table Legs 28.4 x 29.9 Inch Black Table Legs Premium steel table legs with X-frame style Steel Bench Legs Country Style Table Legs Furniture Leg Perfect for Coffee Store Home Office Bar

The legs look great and were uniform. The legs once screwed to the table tended to wobble (about 46 inches apart), as other reviewers stated. The top plate should be wider with more screw holes on both sides would help with stability. I drilled these my self. I also installed 2" steel angle iron between the legs, attaching it inside the top V by drilling two sets of holes in each leg (one in the V and one on either flat - total of 3), on set on out edge of V and other on inside edge, for a total of 6 holes in the angle iron and each leg). I used self-tapping #14 screws, I pre-painted everything black. Came out nice and the table was rock solid.

The table legs are nice looking, great quality and good finish. I custom made a quartz table top for the table legs and used 3/4” plywood to fit inside underneath the table. I also added cross bar pieces of plywood to help support the table from shaking. It’s a lot better now but still shakes a bit. I have 2 suggestions (1) the seams in the table legs need to look seamless as I can see the welding joints at the X (2) the table is unstable even with extra supports (I have quite a bit of supports so it’s now okay but still shakes a bit). I suggest a cross bar at the joining of the X for proper support or at minimum provide the option to buy the support.

It arrived with a few scratches, not well enough packaged, only one layercardboard as protection. Top plate little thin, one mm thicker would have been better. Otherwise nice.

Befestigung funktioniert nur mit "Schrauben um die Ecke", da die Löcher teilweise ungünstig vorgebohrt wurden. Ließ sich für uns leider nicht umsetzen.

Pieds de bonne qualité, correspondent bien à la description du produit. Supportent très bien un plateau de table en chêne massif assez lourd. Deux points pourraient être améliorés : - les vis fournies sont un peu trop petites - les platines de fixation sont sous-dimensionnees : 2 ou 3 cm de plus en largeur aideraient pour la mise en place des vis

Beine stark verkratzt und eingedelt, Schraublaschen fehlen jeweils an einer Ecke, so dass die Beine angeschraubt wackeln. Lieferung war schnell

J’étais très satisfaite

Odnos cijene i kvalitete je prihvatljiv.

Unless you have a specific bent screw driver one side is almost impossible to get the screws into. Flat plate side is ok but the other side that are under the X legs have no room. I’m using longer screws because the table top is a 12ft long 3 inch thick slab of cedar. The short ones that came with the legs (I’m using under the shortest space) are difficult to tap in to start and then the ratchet can’t fit in the tiny space to tighten them. It has been quite exhausting and frustrating.

Top, mais les vis ne sont pas du tout adaptée